RSLogix 5000: Fatal error when adding modules to project

Tagged: 

This topic contains 1 reply, has 2 voices, and was last updated by Fred Graham PLC Guru 4 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #1630
    Mister Incredible
    Mister Incredible
    Participant
    Karma Points: 12
    Rank: Padawan

    Hi everyone, I had an older L61 ControlLogix processor laying around in the office so we decided to use it in a upcoming project we have going on. The processor not the issue, when I try to add modules in the controller tree I keep getting a fatal error and the software crashes.

    The error code its throwing is: 0xE0434F4D

    I do have Studio 5000 installed on the same machine, not sure if this could be causing the issue. Any thoughts…oh and I’m running v20.01.

    Thanks in advance!

    #1632
    Fred Graham
    PLC Guru
    Keymaster

    Hi there! You mentioned you are using version 20.01, there is a new version available, I believe its at v20.04.xx I would try upgrading to the latest for that level.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

A problem is only hard until you know how to solve it…then it's trivial!